Installation; Installation Overview; Preparing The Routing Template - Extron electronics Cable Cubby 300C User Manual

Installation

This section covers the following topics:
•
•
•
•
•

Installation Overview

Install and set up the Cable Cubby enclosures as follows:
1.
2.
3.
4.
5.
6.
7.
8.
9.

Preparing the Routing Template

Extron offers metal templates for each Cable Cubby model; see
Numbers" on page 19 for part numbers. Extron recommends using this template as a
guide to cut the hole in the table where the cubby will be installed.
NOTE: The metal routing template is reusable. Do not discard this template when the
1.
Installation Overview
Preparing the Routing Template
Preparing the Table
Installing the Cables and AAPs
Mounting the Cable Cubby
If you plan to use a mounting template that has not been prepared, prepare the
template (see "Preparing the Routing
Cut a hole in the surface where the enclosure will be installed (see
Table" on the next page).
Run all cables necessary to support the AC connector, the cables stored in the cubby,
and all planned AAP connectors. Leave enough slack in the cables to connect or route
them before the cubby is installed in the table.
If applicable, install the power module. If your location requires electrical conduit, install
an Extron flexible conduit kit. Refer to the Flexible Conduit Kit Installation Guide, Extron
part number 68-734-01.
Install all desired cables into the cable pass-through (split) AAPs and install the AAPs
into the Cable Cubby (see
If applicable, connect cables to the rear connectors on the passive AAPs and install the
AAPs in the cubby (see "Installing the
Mount the Cable Cubby in the table (see
Peel the protective film from the top surface.
Connect the Cable Cubby power cord.
installation is complete. Save it for installing Cable Cubby models of the same size.
Cut 1/2 inch x 4 inch strips of soft, finished lumber to a length that is long enough to
span the distance between the desired installation location on the mounting surface and
the edges of the mounting surface (see
Get other manuals https://www.bkmanuals.com
Template" below).
"Installing the Cables and
AAPs" on page 10).
"Mounting the Cable
figure 4).
Cable Cubby 300/600/800 • Installation
"Preparing the
AAPs" on page 7).
Cubby" on page 10).
"Routing Template Part
4