Table of Contents
Advertisement
im Vertrieb von
Installation
Installation Overview
See figure 2-1 and the following steps to install the HSA 822M:
If desired, install the optional RJ-45 to RJ-11 conversion
1
kit(s) to replace one or more RJ-45 connectors with RJ-11
connectors. Refer to the RJ-45 to RJ-11 Conversion Kit
manual.
If desired, install the optional flexible conduit kit to
2
replace the removable AC power cord. Refer to the
Flexible Conduit Kit manual.
If you have an unprepared mounting template, prepare
3
the template. See Preparing the Routing Template on
page 2-4.
Cut a hole in the surface where the enclosure will be
4
installed. See Preparing the Table on page 2-5.
Run all cables necessary to support the AC, control and
5
status, and RJ-45 connectors and all planned AAP
connectors. Leave enough slack in the cables to connect
them to the underside of the enclosure or to the rear of the
AAPs before the AAPs are installed in the enclosure.
Turn off all of the equipment to be connected. Ensure that
6
the equipment connected to the RJ-45 connectors and the
connections for any AAPs are all turned off and
disconnected from the power source.
If applicable, connect cables to the rear connectors on the
7
AAPs to be installed in the HSA 822M. Install the desired
AAPs on the AAP/RJ-45 panel of the enclosure. See
Cabling and Installing the AAPs on page 2-7.
Route and secure the AAP cables inside the enclosure,
8
install the clamshell, and then secure the AAP cables to
the clamshell. See Routing the AAP Cables and Installing the
Clamshell on page 2-9.
Connect the power, RJ-45, and control and status cables to
9
the underside of the enclosure. Remove the yellow
shipping restraint. See Cabling the Enclosure on page 2-11.
If not already accomplished, peel the protective coating
10
from the top surface and remove rubber strip that protects
the top surface's flanged edges.
Connect power cords and turn on the devices that connect
11
to the surface access enclosure.
www.camboard.de
2-2
HSA 822M • Installation
CAMBOARD Electronics
Tel. 07131 911201
Fax 07131 911203
IN PU
SE
LE
T
CT
CO
MP
AU
UT
DI O
ER
Yellow Shipping
Restraints
REMOVE
IEC Power Cord
RJ-45 Connectors
Figure 2-1 — Mounting the HSA 822M enclosure
ce-info@camboard.de
HSA 822M • Installation
HSA 822
Enclosure
Mounting
Surface
AAP Cables
Clamshell
Motion Control
Connector
Network (TP)
Cables
Flat Washer
Full Thread
Mounting Bolts
2-3
Advertisement
Table of Contents
