Extron electronics MediaLink MLM-WB+ User Manual page 16

im Vertrieb von
Installation, cont'd
Power receptacles and cables
7.
Removing side panels
www.camboard.de
2-10 MLM-WB+ • Installation
CAMBOARD Electronics
c. Connect the ground wire to the junction box and to the grounding poles of
the two duplex power receptacles. Ring terminals may be required for
each lead.
d. Connect the neutral and hot (positive) supply wires to the corresponding
poles on the receptacles. Refer to the instructions that came with the
receptacles, and wrap/insulate any exposed wires.
e. Secure the receptacles and cover to the junction box.
Reconnect power and test the junction box for proper installation.
f.
Route power cables to the 2U and 4U rack enclosures.
a. Remove the left side panel (as viewed from the front) from the MLM-WB+
by loosening the nuts on the inside of the unit and then pushing the panel
out. Set the panel aside.
Tel. 07131 911201
Fax 07131 911203
Loosen nut
to remove
side panel.
ce-info@camboard.de