Installation Overview
•
Planning
(see
page
Check with local and state regulations before starting the installation.
•
Check all parts and equipment before installation.
•
•
Preparing the Cable Cubby F55 Edge
Check the modules for compatibility and installation requirements.
•
•
Installing Modules into the Cable Cubby F55 Edge
Install half-, single-, and double-size modules into the Cable Cubby F55 Edge.
•
Remove any bridge supports if necessary. Note that removal of bridge supports is irreversible.
•
•
(Optional) Installing Retractor Modules (see the Cable Cubby F55 Edge Retractor Guide, provided with
the Cable Cubby F55 Edge Retractor Bracket Kit)
Install Retractor modules in the Cable Cubby F55 Edge.
•
•
(Optional) Attaching a ZipClip
If using a ZipClip, determine which model to use (100, 200, or 400), and in which orientation (vertical or horizontal). Plan
•
and ensure there is ample space for the device and its cables.
or
If using a PMK 155, remove the accessory bracket from the Cable Cubby F55 Edge and attach the bracket to the
PMK 155. Re-install the accessory bracket with the PMK to the Cable Cubby F55 Edge.
Attach the ZipClip or PMK 155 to the Cable Cubby F55 Edge.
•
Attach the desired power supply or other device to the ZipClip or PMK 155.
•
•
Mounting the Cable Cubby F55 Edge
Clamp and secure the Cable Cubby F55 Edge to the edge of the table.
•
•
Routing and Connecting Cables
Organize and connect the cables.
•
Use tie wraps to attach cables to the enclosure where needed.
•
2)
(see
(see
page
6)
(see
page
(see page 9)
page
3)
(see page 4)
(see
page
7)
or PMK 155
8)
to the Cable Cubby F55 Edge
11