Job Aid: Replacing The Samp Power Supply; Replacing The Samp Power Supply On The S8500C Server; Removing The Old Samp Power Supply From The S8500C - Avaya S8500 Series Job Aids For Field Replacements

Job Aid: Replacing the SAMP power supply

!
Important:
Always check the Avaya Support Website for Product Support Notices at
Important:
http://support.avaya.com
products) in the MOST POPULAR PRODUCTS IN SUPPORT section.
This Job Aid contains two replacement procedures:

Replacing the SAMP power supply on the S8500C server

l
Replacing the SAMP power supply on the S8500B server
l
!
Important:
Ensure that you have the proper replacement power supply for the SAMP. The
Important:
replacement parts are not interchangeable.
Replacing the SAMP power supply on the S8500C server
This simple procedure requires two steps:
Removing the old power supply from the S8500B
l
Replacing the power supply from the S8500B
l
!
Important:
Ensure that the replacement power supply is Material ID 700405004 (RoHS
Important:
version) only. You cannot interchange SAMP power supplies.

Removing the old SAMP power supply from the S8500C

To remove the old or defective SAMP power supply from the S8500C server you do not need to
power-down the server:
1. Remove the plug from the power source.
2. Remove the power connection from the SAMP board's RJ11 connector on the rear panel of
the S8500C server.
3. Do not re-use any part of the power supply.
and select Product Support Notices (All Avaya
03-300529 Issue 4 January 2008 135