Powering Down And Disconnecting The S8500 Server; Removing The S8500 Server From The Rack; Removing The Cover Of The S8500 Server - Avaya S8500 Series Job Aids For Field Replacements

Powering down and disconnecting the S8500 server

To power down the S8500 server:
!
CAUTION:
Do not unplug a functioning server without stopping all processes first. Failure to
CAUTION:
do this will corrupt the hard drive.
1. If the server is functional, type stop -h -f on the command line or use the Web page to
shut down the server.
2. If Step 1 does not work, press the power button to shut off the server.
!
CAUTION:
Do not hold down the power button for more than a split second. Holding the
CAUTION:
button down too long causes a reboot of the server.
3. Unplug the power cord from the back of the server.
4. Unplug the power cord from the RSA.
5. Unplug the USB modem cable.
6. Label and disconnect the modem from the RS-232 port on the RSA.
7. Label and disconnect the LAN connection (if used) from the Ethernet port on the RSA.
8. Label and disconnect the cable from the Ethernet port on the dual NIC (if used).

Removing the S8500 server from the rack

To remove the S8500 server from the rack.
1. Pull the server forward so the server rails expand and the retaining clips on the rails click
into place.
2. Using the cross-point (Phillips) screwdriver, remove the server from the slide rails in the
rack.

Removing the cover of the S8500 server

For these steps see
1. Set the server down on a flat surface with an electrostatic mat.
2. Loosen the two captive screws on the back of the server that hold the cover in place.
Removing and replacing the cover on the S8500 server
Replacing the S8500 server
on page 24.
03-300529 Issue 4 January 2008 23