Connections; Weather Resistant Cable Connector - avertX HD438 User Manual

Connections

The AVX-HD438IR cameras use Power over Ethernet (PoE). The only connection on the camera is the
RJ45 Ethernet dongle located on the rear of the camera. Connect one end of the Ethernet cable to the
dongle, and connect the other end to the recorder, or to a PoE switch.
Protect the network cable connection from water damage by running the cord inside a wall or
•
ceiling, or through conduit.
• If passing the cord through a wall or ceiling, drill a 7/8" hole.
For outdoor installations, seal any holes in the wall or ceiling with silicone caulk to protect
•
against water intrusion.
AvertX recommends using Cat5e cable to connect the camera to your network. For the best transmission
quality, the cable length should not exceed 300 feet.

Weather Resistant Cable Connector

This camera features an IP66-rated weather resistant connector. For unprotected outdoor connections,
screw the connector on the included Ethernet camera cable onto the camera dongle. If your installation
location does not require a water-resistant connection, loosen and slide the connector back on the cable
until it's out of the way.
This camera features an IP66-rated waterproof cable connector for unprotected outdoor connections. You
do not need to re-terminate the cable to use the waterproof cable connector.
Included Pieces:
37080AA
Thread Lock Cap
RJ45 Enclosure
11
Silicone Seal Ring
Silicone "O" Ring