Table of Contents
Advertisement
To install the weather resistant cable connector:
1. Slide all pieces of the waterproof cable connector over the cable plug in this order:
Thread Lock Cap
•
Flexible silicone seal ring. You will need to stretch the silicone seal over the RJ-45 plug.
•
Tip:
Insert the flexible silicone seal ring onto the tip of a pair of needle nose pliers and stretch
the seal over the RJ45 plug.
RJ45 Enclosure
•
2. Stretch the small silicone "O" ring onto the camera dongle.
3. Connect the camera cable to the plug on the dongle. Screw the RJ45 Enclosure into the dongle.
4. Insert the flexible silicone seal into the "crown" section of the large plastic ring.
5. Screw the small plastic ring into the large plastic ring.
Tip:
To remove the RJ45 enclosure from the camera cable, tape down the locking tab on
the RJ45 plug with electrical or office tape.
CAUTION:
Do not attempt to disconnect the camera connection without loosening the smaller
thread lock cap. Forcing the assembly will break the camera dongle and void the
camera warranty.
37080AA
12
Advertisement
Table of Contents
