Settings Menu; Configuration Example - Leuze electronic ODS 10 Manual

3.4.6

Settings menu

You can set the display language and call up information about the sensor in the Settings menu.
Level 1
Settings
3.5

Configuration example

≤o illustrate menu operation, the setting of the lower switching point of switching output Q1 to 100 mm is
explained as an example.
 In process mode, press a control button to activate the menu display.
Input
Output Q1
 Press the navigation button
≤he display shows Output Q1 in the upper menu line.
Leuze electronic
Level 2 Level 3
Language
English
German
Display
On
Auto
Auto off
Off
Factory settings
Inactive
Execute
Password Check
Inactive
Activated
Info
Part Number Leuze part number of the sensor
Serial No
Firmware
Revision
.
Description
Setting of the display language
Display language English
Display language German
Display settings
≤he display (measurement value display)
is always at full brightness.
After pressing a control button, the display
is set to full brightness for approx. one
minute and then dims.
≤he display (measurement value display)
is automatically switched off after
30 minutes.
No measurement value display – the dis-
play is only active in the menu after press-
ing a control button.
Reset to factory settings
≤he sensor is not reset to factory settings.
≤he sensor is reset to factory settings.
Locks access to the menu with the fixed password
"165"
Not active
Active
Information on the sensor
Serial number of the sensor
Firmware version
ODS 10
Device description
Default
X
X
X
17