Changing Outputs Tab Settings - Wavetronix SmartSensor HD User Manual

Note. Changing
loop size will affect
occupancy numbers
in the interval
data, but adjusting
these settings will
not modify the
reported vehicle
length or speed.
46
SmartSensor HD User Guide
•

Changing Outputs tab settings

Setting Description
Source
Lets you choose where
SSMHD gets the traffic data
it reports.
RF Channel
Lets you change which
radio frequency channel the
sensor is transmitting on.
Loop Emulation
Size & Makes your system emulate
Spacing
a system with inductive
loops. These settings are
read by a Click contact
closure device, which uses
that information to send
contact closures that are
properly timed to emulate a
given loop size and spacing.
Figure 48. Outputs tab
Details
Choose Antenna for
standard use (reports data
as detected by the sensor).
Choose Diagnostic for
testing and training (creates
simulated traffic).
If you're using multiple
sensors within 70 feet of
each other, set each to its
own RF channel.
Use this if you used the
SmartSensor HD to replace
loops, and the rest of your
system is still configured to
deal with loops. This way
the system keeps getting the
sort of data it expects to see.