Doosan DE08TS Disassembly/Assembly page 64

6
4. Remove camshaft assembly (5) by carefully sliding
it out from the block. Do not force shaft as damage
can occur to the camshaft bearings.
5. Check the conditions of thrust washer (6) and
replace thrust washer (6) if needed.
IEED126P
6. Remove camshaft bushes (7) from the block if
necessary.
DE08TS Diesel Engine
Install Camshaft And Camshaft
Bearing A17174 & A17078-03
5
IEED125P
NOTE : Make an alignment of the oil holes in the
bearing with the oil holes in the engine block.
1. Install a new bushes (7) in place in block if
7
2. Install thrust washer (6). Make an alignment of the
62 of 76
IEED126P
removed.
6
IEED165P
hole in the washer and the dowel in the camshaft.
Disassembly and Assembly
7