Doosan DE08TS Disassembly/Assembly page 18

IEED118P
4. Put the fuel injection pump drive coupling and gear
(9) in position. Make an alignment of the key and
the groove (slot) in the coupling.
5. Install nut (11) that hold the injection pump drive
coupling and gear (9) in place. Tighten nut (11) to
a torque of 130 N� � m (96 lb� � ft).
IEED117P
6. Install nut (10) into the injection pump coupling.
IEED023P
7. Install cover (8), bolts (7) and washers.
DE08TS Diesel Engine
11
9
IEED028P
8. Install bolts (18) and washers that hold the
injection pump on the block.
10
14
IEED026P
9. Connect three hoses (14) and tube (15) to the
injection pump.
8
7
IEED025P
10. Connect accel cable (12) and engine stop cable
(13) to the injection pump.
16 of 76
18
14
12
13
Disassembly and Assembly
15
14