Fcc Regulations; Other Certifications - Planar Wallnet Setup & Operation

FCC Regulations

FCC Regulations
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of FCC rules. These limits are
designed to provide reasonable protection
against harmful interference in an installation.
This equipment generates, uses and can radiated
radio frequency energy, and if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Reorient or relocate receiving antenna.
• Increase separation between equipment and
• Connect equipment to an outlet on a circuit
• Consult your dealer or an experienced
Note: Any changes or modification to the display
not expressly approved by Planar could void the
user's authority to operate this equipment. Use of
a shielded interface cable is required t comply
with the Class A limits of Part 15 of FCC rules.

Other Certifications

FCC Class A, CE Mark
80
receiver.
different from that to which the receiver is
connected.
radio/TV technician.