Planar Wallnet Setup & Operation page 48

Mounting the WallNet for Margay II Displays
3
WARNING!
the power cord when adding or removing an
electronic part.
4
5
6
42
If the power is on, turn it off and remove the
power cord. (For front-access units, reach
through the opening next to the control
board.)
Always turn off power and remove
Remove the bracket from the WallNet
accessory box and place it on top of the M4
threads that are already inside the chassis.
Remove the two nuts from the WallNet
accessory box and use them to secure the
bracket to the chassis.
Snap the back of the WallNet box on the
bracket.