Planar Wallnet Setup & Operation page 47

Mounting the WallNet for
Margay II Displays
1
2
Mounting the WallNet for Margay II Displays
Select the unit in which you want to install
the WallNet device.
Do one of the following:
• For front-access units, remove the screen.
Loosen the screws that hold the control
board in place and carefully lift it off of the
tab holders on the bottom of the chassis.
• For rear-access units, hold the tab on the
control board and loosen the screws on
the back of the unit that hold the control
board in place. Continue holding the tab
on the control board, carefully push it in
and lift it off of the tab holders on the
bottom of the chassis.
41