About The Aux Rs232 Connector - Planar Wallnet Setup & Operation

About the AUX RS232 Connector

The short power cable (supplied) will connect
from the server power connector to the +5V Out
on the bottom of the control board. (For RP/RX,
this will connect to the SIB inside the chassis.) Do
not connect it yet.
About the AUX RS232 Connector
This connector is supplied on the control board of
the SP, RP, RX and Margay II displays for
connection to the WallNet device server. This
leaves the RS232 In connector free for the use of
another control system.
47