Planar Wallnet Setup & Operation page 42

Mounting the WallNet for the LED Series, c50RP/c67RP, c50RX/c67RX and
Mounting the WallNet for the
LED Series, c50RP/c67RP,
c50RX/c67RX and c80RP
Displays
1
2
3
WARNING!
the power cord when adding or removing an
electronic part.
36
Select the unit in which you want to install
the WallNet device.
Do one of the following:
• For front-access units, remove the screen.
• For rear-access units, loosen the screws on
the back of the unit that hold the control
board in place. Swing the control board
inside the chassis.
If the power is on, turn it off and remove the
power cord. (For front-access units, reach
through the opening next to the control
board.)
Always turn off power and remove