Loading The Software Into Wallnet; Miscellaneous Configuration; Reset To Factory Default - Planar Wallnet Setup & Operation

Loading the Software into WallNet

Note:
.wn extension.
Loading the Software into WallNet
1
2
3

Miscellaneous Configuration

The following sections refer to miscellaneous
options that can be set up on the WallNet
Software page.

Reset to Factory Default

Use this to reset ALL settings to the factory
default. This includes network settings, date and
time, etc., as well as display settings like RS232
IDs and email report and alert options.
Caution: Using this option will reset all of your
configurations and reboot the WallNet hardware.
Because this includes network settings, be aware
that the WallNet may not configure to the same
network address after the system reboots.
When you click Reset ALL to Factory Default,
you receive the Confirm Factory Reset page. Click
OK if you are sure you want to reset ALL settings
to the factory default.
30
WallNet software file names end with the
In your browser, click the Back button until
you return to the WallNet page.
In the menu area of the WallNet page, select
WallNet Software. In the main area, scroll
down to the Load WallNet Software section
and follow the directions. Return to step 3 of
this section to continue. Loading new
software takes one to two minutes.
In the menu area, select Reboot WallNet,
and then click Reboot WallNet now. This
takes about 90 seconds.