Network Remote Control; Custom Commands Setup - Planar Wallnet Setup & Operation

Network Remote Control

Network Remote Control
The Network Remote Control window shows a
graphic of a remote control. Be careful with this
control, as clicking on the buttons will send
commands to the display screens. Unless you are
looking at the display screen, it is suggested that
you do not use this tool.

Custom Commands Setup

Custom Commands allow you to establish what
the ten Custom Command buttons will do.
1
2
3
4
5
6
66
In the menu area, select Custom Commands
Setup.
Type a label for the button in Button # Text.
In ASCII Command(s), enter the ASCII
commands to be sent when that button is
clicked.
If more than one command is required,
enter each command on a separate line in
the box.
Click Test button # commands to send the
commands immediately. You will see an
output page showing the commands sent
and replies received (if any). Use the
browser's Back button to return from this
results page to avoid losing unsaved
changes. If you select the Custom
Commands Setup section again, you will
lose unsaved changes.
Scroll to the bottom of the Custom
Commands Setup page and click Change
Custom Command Buttons. This applies
what you have done to the custom buttons
accessed from Custom Commands at the
top of the left menu.