Planar Wallnet Setup & Operation page 23

3 After a minute or so, the CPU light will start
blinking: on one second, off one second.
Count at least 30 seconds (15 times LED is
on).
4 Connect WallNet to the network.
5 Connect your computer (with the known IP
address) to the same network. DO NOT
connect the computer and WallNet directly
to each other, unless you are using a
crossover cable. They can only
communicate over a correctly configured
network.
6 Do one of the following:
• Using the WallNet Assistant program, click
• Type this on one line exactly as shown
route add 192.168.12.0
mask 255.255.255.0 <PC IP
address>
7 Press [Enter]. This action tells the network
that your computer can point to this
WallNet, but so far, yours is the only
computer that can.
8 Start your browser and point to:
http://192.168.12.12
1. 192.168.12.0 is a network address.
2. 192.168.12.12 is the default address of the WallNet.
the Route Add Cmd button to
automatically run the route add
command.
(except substitute your PC's IP address)
Connecting to WallNet
2
1
:
17