Custom Commands; Message In Picture; Reports And Alerts; Periodic Reports - Planar Wallnet Setup & Operation

Custom Commands

You need View authority to do anything here.
These ten buttons send commands that are set
up in Custom Commands Setup, are described on
page 66. You need Operator authority to set up
the buttons, but only View authority to use them.

Message In Picture

You need Operator authority to do anything here.
Note:
Message In Picture displays a message over the
source picture. You can compose and display the
messages in this section. See the MIP Maker
program and the MIP Guide from the Planar
website for information about this feature.
In the Menu section, click on an MIP type to write,
display or hide the message.

Reports and Alerts

You need Operator authority to do anything here.

Periodic Reports

Three types of reports gives you great flexibility in
reporting:
• Scheduled Report sends an email daily,
• Running Time Report uses the Running
• Lamp Age Report looks at the hours of all
MIP is not supported in all products.
weekly or monthly.
Time of only one of the displays: the first one
in the RS232 Setup list.
the lamps in all the displays. Therefore it is
important to reset the lamp hours when
lamps are changed. This report is only
applicable to lamp illuminated rear
projection cube products.
Custom Commands
53