When To Load Wallnet Software; Software Vs. Firmware; Getting Ready To Set Up Wallnet - Planar Wallnet Setup & Operation

When to Load WallNet Software

When to Load WallNet Software
First, complete the general setup described in
this manual until you have established network
settings for your WallNet. Save the configuration.
Then follow the instructions on page 29 to load
the new WallNet software.
When you load new WallNet software, the saved
settings (such as network setup) are preserved.
Therefore, it is important during the first
configuration to save the configuration before
loading new software.

Software vs. Firmware

In this manual and on the WallNet web pages,
software is loaded into the WallNet itself to
update it or change between supported sets of
displays.
Firmware is loaded into the display to update the
operation of the Planar display itself.

Getting Ready to Set Up WallNet

DO NOT apply power to the WallNet device server
yet!
DO NOT connect it to the network yet!
4