Product Id Link; Advanced Settings; Saving The Configuration - Planar Wallnet Setup & Operation

Product ID Link

The top of each WallNet page shows a product
name (for example, Margay II or RP/RX). By
default, this is a link to
can change this link to refer to any URL that you
find useful.

Advanced Settings

For products with SiFi, WallNet polls the displays
at a rate of one per second to look for user
requests that have been made using the IR
remote control and the on-screen menus. In
some situations, this polling can have a
noticeable performance impact. If you want to
disable this polling, check the Disable polling for
user request entered via IR remote checkbox.
When you are finished, click Change Advanced
Settings.
For products with SiFi, WallNet uses Message In
Picture (MIP) Banner 1 to display progress
messages and to warn of impending scheduled
ACB and lamp switch operations. To disable the
use of MIP for user messages, check the Disable
MIP for ACB and lamp switch messages
checkbox. When you are finished, click Change
Advanced Settings.
There may be additional advanced settings
depending on product type. Read the on-screen
instructions in the advanced settings section for
more information.

Saving the Configuration

Similar to other WallNet settings, changes are
effective immediately. However, in order for the
changes to become permanent, you must save
the entire WallNet configuration. See "Save
WallNet Config" on page 25.
http://www.planar.com
Product ID Link
. You
31