Save And Reboot; Save Wallnet Config; Reboot Wallnet - Planar Wallnet Setup & Operation

Save and Reboot

Save and Reboot
You need Operator authority to do anything here.

Save WallNet Config

Whenever you change any of the settings, such as
Periodic Reports, Automatic Alerts, RS232 Setup,
etc., the changes take effect immediately.
However, if power is lost to WallNet, these
changes will be lost.
It is good practice to copy these changes from
the WallNet RAM to the flash memory, where it is
permanently stored (until you save it again).
1
2
This action copies everything in RAM to flash
memory.

Reboot WallNet

If you make changes that have not yet been
saved and decide to go back to the previous
settings, reboot WallNet.
1
2
This copies everything in flash memory to RAM.
RAM memory is used for all current operations.
When power is applied to WallNet, flash memory
is copied to RAM.
Reboot takes about 90 seconds.
68
In the menu area, select Save WallNet
Config.
Click Save configuration settings now.
In the menu area, select Reboot WallNet.
Click Reboot WallNet now.