Set Display Ids In Wallnet - Planar Wallnet Setup & Operation

Set Display IDs in WallNet

Set Display IDs in WallNet
Use the following instructions to set these same
numbers in a list in WallNet.
1
2
Note:
rates that are not supported by WallNet. Some
advanced features, such as Auto Color Balance,
require higher baud rates to succeed.
3
Note:
display IDs are set to a unique value and that the
baud rate settings match.
4
5
28
In the menu area, select RS232 Setup.
Select the baud rate at which the displays
✎
are set. (See
Settings.
Your displays may support lower baud
If you want to view the on-screen serial
status menu, click Show RS232/RS485
Status Menu under the Serial Port Status
section. To hide the menu, click Send Menu
Key.
This is useful if you want to verify that all
Under the Enter Display IDs section, list the
display IDs in the box. Separate the IDs with
a space, comma, or put them on separate
lines. Click Change RS232 Settings.
If you want to confirm communication to
each individual display, do one of the
following under the Confirm RS232 Setup
section:
• Click Report to browser only.
• Click Report to browser and on screen.
• Click View firmware version
information.
When you are finished viewing the
information, click Clear on-screen
messages, if necessary.
The information in the report includes the
display model, firmware part number and
revision, and firmware compile date.
above.) Click Change RS232