Planar Wallnet Setup & Operation page 26

Network Setup
6
7
8
✎
If you have changed the static IP address or
changed from static to DHCP setup, you may need
to point your browser at the new address or use
WallNet Assistant to find the new address.
9
✎
If you lose contact with WallNet after changing net-
work settings, see "Recovery Procedures" on
page 75.
20
Settings section. However, if you do,
these settings will be used in the event
that the DHCP attempts to time out.
c. Go to step 7.
Under the DHCP section, choose No, use
static settings.
a. In the Static (non-DHCP) Network Set-
tings section, enter the IP address
given to you by the network administra-
tor.
b. Enter the Network mask, DNS
server(s), and Gateway as instructed by
the network administrator.
c. Go to step 7.
Scroll to the bottom of the page and click
Confirm and apply new network settings
to receive the Confirm Network Change
page.
Review the settings to make sure they are
correct. Click OK, apply changes now to
receive the Applying Network Changes
page.
This shows the network settings to be used.
You may have to click the Refresh button
on your browser to see the new WallNet
name in the upper left.