Planar Wallnet Setup & Operation page 51

✎
To remove the server, use a small screwdriver to pull
release the latch.
11 Do one of the following:
12 Go to "Cable Connections to the WallNet
Mounting the WallNet for Margay II Displays
Bottom of server
showing spring latch
• For front-access units, carefully place the
tabs on the bottom of the control board
into the slots inside the chassis. Push the
control board towards the outside of the
chassis and tighten the screws that secure
the control board to the chassis. Replace
the screen.
• For rear-access units, carefully place the
tabs on the bottom of the control board
into the slots inside the chassis. Hold the
tab on the control board as you pull it
towards the outside of the chassis.
Continue holding the control board as
you retighten the screws.
Box" on page 46 to continue.
45