Planar Wallnet Setup & Operation page 39

Mounting the WallNet for
c50SP/c67SP/c70SPw
Displays
For c50SP/c67SP/c70SPws, the WallNet device
server (the little box) can be mounted in one of
the displays.
1
2
Mounting the WallNet for c50SP/c67SP/c70SPw Displays
Mount the small bracket on the floor of the
chassis below the control board.
Connect cables to the WallNet device server.
a. Connect the 9-pin adapter to device
server.
b. Connect the short network cable (sup-
plied) to the adapter.
c. Connect the other end of the short net-
work cable to the AUX RS232 connector
at the bottom of the control board. (The
clip side of this connector faces away
from the lettering on the face of the
control board.)
d. Connect the short power cable to the
server. DO NOT CONNECT this power
cable to power yet.
33