Save And Reboot Wallnet; Wallnet Uses Cookies; Loading New Software Into Wallnet; Getting New Wallnet Software - Planar Wallnet Setup & Operation

Save and Reboot WallNet

1
2
3
4

WallNet Uses Cookies

WallNet uses cookies on your computer to
differentiate between various computers that it
might communicate with. It uses cookies only to
remember the ID of the last display selected.
If your browser restricts cookies, you may want to
allow the WallNet cookie. It's not particularly
useful to do this until after the WallNet IP address
is set.

Loading New Software Into WallNet

If you want to load new software to the WallNet
device server, you can connect to
www.planar.com
logo in the upper right corner.

Getting New WallNet Software

Go to
1
2
In the menu area, select Save WallNet
Config.
Click Save configuration settings now.
Wait while the settings are saved to flash
memory in the box. The box will tell you
when it has finished.
Select Reboot WallNet in the left menu.
Click Reboot WallNet now. Wait about 90
seconds for the reboot to complete.
quickly by clicking the Planar
www.planar.com
Navigate to the section that contains
software updates and then look for WallNet.
Here you will find the latest software for
WallNet.
Select the software you want and save it to
your hard drive. Make a note of the
location of this file. You will need to
browse to this file in a later step.
Save and Reboot WallNet
.
29