Scheduled Color Balance - Planar Wallnet Setup & Operation

Auto Color Balance
Note:
from the target point due to screen color.
To start an immediate ACB, click the Balance Wall
Colors Now button. You will see detailed
information that shows the progress of the ACB.
This information is mainly intended for diagnostic
purposes.
View Last ACB Result shows the detailed output
of the last Auto Color Balance. This is useful for
viewing diagnostic information after a scheduled
ACB or one started in the menu system using the
IR remote.
View Diagnostic Output shows RS232
transactions and details of the ACB process,
which are useful for troubleshooting.

Scheduled Color Balance

For the LED series, ACB can be scheduled to run
automatically every month, two months, three
months, four months or six months.
For lamp-based systems, ACB can be scheduled
to run daily, weekly or monthly.
The schedule is not active until the checkbox is
checked and you click Change Color Balance
Schedule. At the scheduled time, WallNet will
warn of the impending color balance for five
minutes using Message In Picture. After the five-
minute warning period, it can take up to several
minutes to balance a wall for color and
brightness. The exact timing depends on the
display product type, communication speeds,
and the size of the wall. The best way to
determine the expected time is to measure the
ACB process for your wall during installation.
60
Measured white point may vary slightly