Fault Messages - BONFIGLIOLI Vectron Agile Series Communications Manual

18.2 Warning Messages Application
When the highest bit in the Warning messages is set, a "Warning Message Application" is present.
The Application warning messages are given via parameter
according to the following scheme.
Application Warnings
Parameter
the PC software tool VPlus.
Application Warnings
Use Parameter
Bit-No. Warning
Code
0 0x0001
1 0x0002
2 0x0004
3 0x0008
4 0x0010
5 0x0020
6 0x0040
7 0x0080
8 0x0100
9 0x0200
10 0x0400
11 0x0800
12 0x1000
13 0x2000
14 0x4000
15 0x8000
Note: The meaning of the individual warnings are described in detail in the operating
instructions.
18.3 Error Messages
The error code that is stored after a fault occurs is made up of the fault group FXX (high Byte,
hexadecimal) followed by the code number XX (low Byte, hexadecimal).
Code
F20 62 Profibus OFF (communication connection to DP Master lost)*
F26 02 Communication watchdog CM-PDPV1 / inverter controller
* This message only appears whenever
The Actual error message can also be read out by parameter access via parameter
260.
Actual Error
Parameter
software tool VPlus.
In addition to the fault messages stated, there are further fault messages used for internal purposes
only and which are not listed here. If you receive any fault messages which are not listed, please
contact us by phone.
60
273 shows the warnings in clear text on the operator panel and
274 to access the Application warning codes via Profibus.
Warning Messages
BELT
(reserved)
(reserved)
(reserved)
(reserved)
(reserved)
SERVICE
User 1
User 2
(reserved)
(reserved)
(reserved)
(reserved)
(reserved)
(reserved)
(reserved)
Communication Fault
Meaning
Profibus Error Reaction
259 shows the actual error in clear text on the operator panel and the PC
Profibus DP V1 Agile
Application Warnings
Description
393 = 1 – Error.
Annex
274, bit-coded
Actual Fault
06/2010