30 Testing and adjusting
Default (Camera)
Check or change various settings related to the
machine monitor and machine by "Default".
The camera setting function is used to set installa-
tion and removal of a camera.
1.
Selecting menu
Select "Default" on the "Service Menu" screen.
2.
Selecting sub menu
After the "Default" screen is displayed, select
"Cam era" with the function switches or
numeral input switches.
a Select this item similarly to an item on the
"Service Menu" Screen.
PC300, 350-8
3.
Selecting camera setting
After the "Camera" setting screen is displayed,
select the setting with the function switches.
OFF: Camera is not used
q
Original Image: Image of connected cam-
q
Reverse Image: Image of connected cam-
q
[F3]: Move to left item
q
[F4]: Move to right item
q
[F5]: Cancel setting before confirmation
q
and return to "Default" screen
[F6]: Confirm selection in each line
q
a After "Camera" screen is displayed, cam-
era 1 can be always set. When 2 or more
cameras are connected, if camera 1 is set,
the screen changes to setting of camera 2
automatically.
a After confirming the setting of each line
with [F6], return to the "Default" screen
with [F5], and the setting is effective.
a If a camera is connected but not set nor-
mally with this function, the graphic mark
of camera is not displayed at [F3] in the
operator mode. Accordingly, the image of
the camera cannot be used.
a If 2 or more cameras are connected, be
sure to set the use of them from camera 1
in order.
a The function of displaying 2 images simul-
taneously is effective when use of camera
1 and camera 2 is set.
a When a camera is installed, check that the
displayed image is not inverted horizon-
tally.
SEN02626-04
era is displayed in origi-
nal position (as in mirror,
used as back monitor)
era is displayed in reverse
position (as seen directly,
used as front or side mon-
itor)
43