Komatsu ecot3 PC300LC-8 Shop Manual page 414

SEN02626-04
Display of warning after check before starting
If any abnormality is detected by the check before
starting, the warning monitor is displayed on the
screen.
a The following figure shows that the engine oil
level monitor (a) is warning of low of engine oil
level.
Display of ending of maintenance interval
When the check before starting is carried out, if a
maintenance item is near or after the end of the set
interval, the maintenance monitor is displayed for
30 seconds to urge the operator to maintenance.
a This screen is displayed only when the mainte-
nance function is effective. The color of the
maintenance monitor (yellow or red) indicates
the length of the time after the maintenance
interval.
a Set or change the maintenance function in the
service mode.
a After display of this screen is finished, the
screen changes to "Display of check of work-
ing mode and travel speed".
8
Display of check of working mode and travel
speed
If the check before starting is finished normally, the
screen to check the working mode and travel speed
is displayed for 2 seconds.
a After display of check of the working mode and
travel speed is finished, the screen changes to
"Display of ordinary screen".
Display of ordinary screen
If the machine monitor starts normally, the ordinary
screen is displayed.
a Service meter (a) or a clock is displayed at the
center upper section of the screen (The ser-
vice meter or clock is selected with [F4]).
a ECO gauge (b) is displayed at the right end of
the screen (It is turned ON and OFF in the ser-
vice mode).
30 Testing and adjusting
PC300, 350-8