Komatsu ecot3 PC300LC-8 Shop Manual page 990

SEN02641-02
a Never apply the wrong primer.
If the glass primer, etc. is applied by mistake,
wipe it off with white gasoline.
4) Apply the glass primer to the sticking sur-
faces of window glass (9).
2
Glass primer:
Sunstar primer for glass 580
super or equivalent
a Do not apply the primer more than 2
times.
(If it is applied more than 2 times, its
performance will be lowered.)
a Parts to be coated with primer; Apply
the primer to all around of sticking
surface (d) of window glass (9) for
dam rubber (6) installation position
and operator's cab (8).
a Do not apply the primer to the
boarder about 5mm wide between the
black part and transparent part of the
glass.
a After applying the primer, leave it for
at least 5 minutes (within 8 hours) to
dry.
a Never apply the wrong primer.
If the paint primer, etc. is applied by
mistake, wipe it off with white gaso-
line.
8
50 Disassembly and assembly
4. Stick dam rubber
tape)(6) along the inside edge of the glass
sticking section.
a Do not remove the release tape of dam
rubber on the glass sticking side before
sticking the glass.
a When sticking the dam rubber, do not
touch the cleaned surface to the utmost.
a Care should be taken not to float the dam
rubber of each sticking corner.
a When sticking dam rubber (6) around a
frame, do not lap its finishing end over the
starting end. Or, make clearance of about
5 mm between them (e).
1) Stick dam rubber (6) for right side window
glass (1) to the position as shown in the
figure.
(both-sided adhesive
PC300, 350-8