Table of Contents
Advertisement
SEN02641-02
Removal and installation of
operator's cab assembly
Removal
k
Disconnect the negative (–) terminal from
battery.
1.
Remove front window (1).
2.
Remove step plate (2).
3.
Remove floor mat (3).
4.
Refer to "Removal and installation of monitor
assembly", and remove monitor assembly (4).
5.
Remove covers (5) and (6).
6.
Remove cover duct assembly (7).
7.
Insert key (8), turn it right, and open the out-
side-air filter cover.
8.
Remove outside-air filter (9).
2
50 Disassembly and assembly
9.
Remove rear covers (10) to (13).
10. Remove duct (14).
11. Remove cover (15).
a Disconnect connector H15 fixed on the
back from the clip.
12. Remove plate (16).
13. Remove plate (17).
14. Remove lock pin (18) and remove duct (19).
PC300, 350-8
Advertisement
Table of Contents
Troubleshooting
