Komatsu ecot3 PC300LC-8 Shop Manual page 447

30 Testing and adjusting
Default (With/Without Attachment)
Check or change various settings related to the
machine monitor and machine by "Default".
The "With/Without attachment" function is used to
set an installed or a remove attachment.
1. Selecting menu
Select "Default" on the "Service Menu" screen.
2. Selecting sub menu
After the "Default" screen is displayed, select
"With/Without Attachment" with the function
switches or numeral input switches.
a Select this item similarly to an item on the
"Service Menu" screen.
3. Selecting With/Without
After the "With/Without Attachment" screen is
displayed, select the setting with the function
switches.
Without Attachment:
q
When attachment is not installed
With Attachment:
q
When attachment is installed
[F3] : Move to lower item
q
[F4] : Move to upper item
q
[F5] : Cancel selection and return to
q
Default screen
[F6] : Confirm selection and return to
q
Default screen
PC300, 350-8
a When an attachment is installed, if this
setting is not carried out normally, the
attachment cannot be set in the operator
mode. As a result, the attachment may not
work normally or the hydraulic compo-
nents may have trouble.
SEN02626-04
41