50 Disassembly and assembly
5.
Ring gear
Remove the mounting bolts to remove ring
gear (10).
6.
No.2 sun gear
Remove No. 2 sun gear (11).
7.
No.2 carrier assembly
1)
Remove mounting bolt (12) and No. 2 car-
rier assembly (13).
PC300, 350-8
2)
Disassemble No. 2 carrier assembly as
follows.
1]
Insert pin (14) and drive shaft (15) out
of carrier (16).
a After removing the shaft, remove
pin (14).
2]
Remove thrust washer (17), gear
(18), bearing (19), and thrust washer
(20).
3]
Remove plate (21).
8.
Shaft assembly
1)
Remove 12 mounting bolts (23).
2)
Set the shaft and case assembly on the
press and then, using push tool [2],
remove shaft assembly (24) from case
assembly (25).
SEN02637-02
13