Table of Contents
Advertisement
Installation
Prepare Appliance for Wiring
Decorative Lighting and Remote Battery & Wall
Switch Kit (RBWSK)
The fi replace is equipped with a decorative lighting
located above the fi rebed inside the fi rebox. The
lighting is pre-wired at the factory and must be
connected to the electrical system of the home
PRIOR to the fi nal positioning of the fi replace into
the framing. The decorative lighting is operated by the
fi replace's remote control handset.
Wiring for the overhead lighting and RBWSK kit
is accessible from the rear panel of the appliance
and therefore it should be done BEFORE the fi nal
positioning of the fi replace in the framing.
WARNING
All electrical installations must be
performed by a qualified electrician and
must be electrically wired and grounded
in accordance with local codes, or, in the
absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 or the
Canadian Electrical Code, CSA C22.1.
The fi replace's upper decorative lighting is connected to
the v-module box located behind the appliance's front
panel below the window. It is hidden under the valve
shield. The v-module is powered by a three-prong plug
plugged into a receptacle inside the appliance case, at
the rear, on the left-hand side.
28
1. At the back of the fi replace case, on the left-hand
side, remove the electrical box cover (4 screws).
RBWSK wire
harness
inlet
Appliance rear view
2. Remove a knock-out cover for the electrical connec-
tion needed for incoming power.
3. Rough in the wiring harness for the
mote Battery & Wall Switch
one of the holes to the left of the electrical panel
both the power connector and the white connector
end of the wire harness to reach the receiver at the
front of the appliance, about 3 feet (36 cm).
RBWSK
power
connector
RBWSK
white connector
4. Refi t the electrical box cover.
Electrical Wiring
Gas
inlet
tube
Electrical
box cover
RBWSK—Re-
Kit. Thread through
Advertisement
Table of Contents
