Table of Contents
Advertisement
QUALIFIED
INSTALLER
Only qualifi ed licensed or trained personnel
should install this appliance.
Installer—READ THIS FIRST
1. YOU NEED TO KNOW FROM THE
HOMEOWNER what accessories (surround,
etc.) will be installed with this fi replace;
2. Unpack the appliance.
3. Check that you have everything.
4. Clean cavity, chimney, ash dump, and clean-out.
5. Install venting pipes.
6. Attach conversion plate to existing fi replace.
7. Install and test fan (blower) if used.
8. Fit appliance into cavity.
9. Connect and test gas supply.
10. Install ceramic liners if used.
11. Install logs.
A few points must be considered before inserting the
739-72 into an existing fi replace cavity. Generally, no
modifi cations are allowed to the existing fi replace that
will compromise the integrity of the existing fi replace.
Components that are bolted or screwed on such as
dampers or baffl es may be removed to accommodate
the installation of the 739-72 engine. Cutting away
any sheet metal parts of the existing fi replace
to accommodate the installation of the 739-72 is
prohibited. Check with local authorities if in doubt.
Clean Fireplace and Chimney
Have the chimney swept and the fi replace cavity
including ash dumps and clean-outs cleaned before
installing the 739-72 heater and vent liners. Any
creosote or soot residue remaining in the fi replace
cavity chimney or clean-out may cause odors or
stains once the 739-72 insert is installed. Consult with
chimney sweep for information on how best to clean.
22
Installation Planning
Existing Fireplace Preparation
12. Refi t window.
13. Put batteries in receiver and remote control
handset.
14. Set-up remote control.
15. Connect electrical wiring fan (blower) if used.
16. Verify operation and adjust aeration settings.
17. Install the remote control handset wall holder.
18. Instruct the homeowner on the operation and
maintenance of the fi replace.
19. Install the surround trim, front and barrier screen.
Existing Dampers
Factory-built, zero-clearance fi replaces will require the
damper to be removed in order to install the vent liners.
These dampers are usually bolted into place. Dampers
in masonry fi replaces must be fi xed open and may
remain in place.
Ash Retaining Curbs
Some fi replaces (particularly factory-built) have a
raised curb at the front edge to retain ashes. Check the
dimensions carefully to ensure the 739-72 engine will fi t
behind any raised curb (some curbs may be removed
separately from the refractory base).
Advertisement
Table of Contents
