Inter Ap Blocking; Basic - Siemens SIMATIC NET SCALANCE W780 Series Configuration Manual

Configuring with Web Based Management
6.9 "Security" menu
● VAP X.Y
Specify whether the station (or the IP address) accesses the device via the VAP
interface.
● WDS X.Y
Specify whether the station (or the IP address) accesses the device via the WDS
interface.
Procedure
Note
Note that a bad configuration may mean that you can no longer access the device.
You can then only remedy this by resetting the device to the factory defaults and then
reconfiguring.
Changing the entry
1. Configure the data of the entry you want to modify.
2. Click the "Set Values" button to transfer the changes to the device.
Creating new entry
1. In the "IP Address" input box, enter the IP address of the device and in the "Subnet Mask
/ Prefix Length" input box the corresponding subnet mask.
2. Click the "Create" button to create a new row in the table.
3. Configure the entries of the new row.
4. Click the "Set Values" button to transfer the new entry to the device.
Deleting entries
1. Select the check box in the row to be deleted.
2. Repeat this procedure for every entry you want to delete.
3. Click the "Delete" button. The entries are deleted and the page is updated.
6.9.8

Inter AP blocking

6.9.8.1

Basic

Note
• This WBM page is only available in access point mode.
• This WBM page can only be configured with the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5 907-8PA00)
– W700 Security (MLFB 6GK5907-0PA00)
400
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13