Siemens SIMATIC NET SCALANCE W780 Series Configuration Manual page 329

● Status
Shows the status type of the entry in the port filter table. Here, static means that the
address was entered as a static address by the user.
● List of ports
Specify the use of the port. The following options are available:
– "-"
– M
– U (uppercase)
– u (lowercase)
– F
– T
Changing Base bridge mode
VLAN-unaware (802.1D transparent bridge) → VLAN-aware (802.1Q VLAN bridge)
If you change the Base Bridge mode from VLAN-unaware to VLAN aware, this has the
following effects:
● All static and dynamic unicast entries are deleted.
VLAN-aware (802.1Q VLAN bridge) → VLAN-unaware (802.1D transparent bridge)
If you change the Base Bridge mode from VLAN-aware to VLAN-unaware, this has the
following effects:
● All VLAN configurations are deleted.
● A management VLAN is created: VLAN 1.
● All static and dynamic unicast entries are deleted.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
The port is not a member of the specified VLAN.
With a new definition, all ports have the identifier "-".
The port is a member of the VLAN. Frames sent in this VLAN are forwarded with the
corresponding VLAN tag.
The port is an untagged member of the VLAN. Frames sent in this VLAN are
forwarded without the VLAN tag. Frames without a VLAN tag are sent from this port.
The port is an untagged member of the VLAN, but the VLAN is not configured as a
port VLAN. Frames sent in this VLAN are forwarded without the VLAN tag.
The port is not a member of the specified VLAN. You can configure other settings in
"Layer 2 > VLAN > Port Based VLAN".
This option is only displayed and cannot be selected in the WBM.
This port is a trunk port, making it a member in all VLANs.
You configure this function in the CLI (Command Line Interface) using the "
" command.
mode trunk
Configuring with Web Based Management
6.7 "Layer 2" menu
switchport
329