Siemens SIMATIC NET SCALANCE W780 Series Configuration Manual page 99

● DCP Server
Specify whether or not the device can be accessed with DCP (Discovery and
Configuration Protocol):
– "-" (disabled)
– Read/Write
– Read Only
● SNMP
Select the protocol from the drop-down list. The following settings are possible:
– "-" (SNMP disabled)
– SNMPv1/v2c/v3
– SNMPv3
● SNMPv1/v2 Read-Only
Enable or disable write access to SNMP variables with SNMPv1/v2c.
● SINEMA configuration interface
If the SINEMA configuration interface is enabled, you can download configurations to the
device via the TIA Portal.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
DCP is disabled. Device parameters can neither be read nor modified.
With DCP, device parameters can be both read and modified.
With DCP, device parameters can be read but cannot be modified.
Access to device parameters via SNMP is not possible.
Access to device parameters is possible with SNMP versions 1, 2c or 3. You can
configure other settings in "System > SNMP > General".
Access to device parameters is possible with SNMP version 3. You can configure
other settings in " System > SNMP > General".
Configuring with Web Based Management
6.3 "Wizard" menu
99