Connecting The Replenishment Tanks And Strainers - Kodak X-OMAT Multiloader 300 Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Note
•
Kodak suggests a:
- PRESSURE GAUGE to monitor the water pressure
- tempered water supply for cleaning the PROCESSOR and for mixing
chemicals manually.
•
The PROCESSOR has an internal 2.54 cm (1.0 in.) water gap in the WASH RESERVOIR.
A CHECK VALVE or VACUUM BREAKER should not be necessary, unless local codes
require one.

CONNECTING THE REPLENISHMENT TANKS AND STRAINERS

Note
Customers may use internal or external REPLENISHMENT TANKS or a chemical mixing system.
An example of a chemical mixing system is a Kodak AUTOMIXER III. To install a chemical mixing
system, use the installation instructions for the system.
1. Install and connect the REPLENISHMENT TANKS or chemical mixing system to the
PROCESSOR.
•
Use 3/8 - in. ID HOSE.
•
Install the STRAINERS in the HOSES.
2. If the customer has a Silver Recovery System, install it.
2 HOSES
8/1998
2 external REPLENISHMENT TANKS
figure 4-7
4-6
II 3058-4
2 STRAINERS
KODAK AG Stuttgart