Kodak X-OMAT Multiloader 300 Installation Instructions Manual page 132

INSTALLATION INSTRUCTIONS
5. Connect the LAP TOP to the rear connector of the XML300 / XML 300 Plus.
RS232 CONNECTOR for the Lap Top
6. Energise the XML300 / XML 300 Plus. Take out the MAGAZINES and take off the
PANELS.
7. Start the SERVICE SOFTWARE and record the parameter settings for safety reasons.
Key in: CD\XML300 .......................................................................press ENTER
Key in START ....................................................................................press ENTER
Select SERVICE MODE from the GLOBAL MENU ...................press ENTER
ENTER SERVICE MODE MESSAGE is displayed........................press ENTER
UNIT DATA ARE displayed..........................................................press ENTER
Select CHANGE ML300 DATA from the MAIN MENU ...........press ENTER
Select CHANGE PARAMETER ......................................................press ENTER
Record the values of all PARAMETERS
Press BACKSPACE twice to go back to the MAIN MENU
8/1998
figure 13-13
13-16
II 3058-4
KODAK AG Stuttgart