Connecting The Drains - Kodak X-OMAT Multiloader 300 Installation Instructions Manual

II 3058-4

CONNECTING THE DRAINS

Warning
DRAINS must be made of chemical resistant, non-corrosive material. Use PVC or the equivalent.
1. Check that the DRAINS comply with the following requirements:
Subject
Minimum diameter
Distance from the PROCESSOR
Height from the floor
HOSES
Connections to the DRAIN
* The customer can obtain these parts from Kodak:
Part No.
696441 1 in. Reinforced HOSE for the DRAIN
696442 5/8 in. Reinforced HOSE for the DRAIN
1C4521 5/8 in. ELBOW for the DRAIN
1C4524 1 in. ELBOW for the DRAIN
KODAK AG Stuttgart
7.6 cm (3 in.)
1.5 m (60 in.) maximum
flush with the floor
Reinforced HOSE that will not kink is recommended *
Corrosive resistant connections should be flexible, not solid.
ELBOWS are recommended. *
Description
For optional
SILVER RECOVERY UNIT
DEVELOPER
OVERFLOW
FIXER
OVERFLOW
FIXER DRAIN
Requirements
figure 4-8
4-7
INSTALLATION INSTRUCTIONS
Quantity
Order by the foot
DEVELOPER
REPLENISHMENT
WATER SUPPLY
INLET
FIXER
REPLENISHMENT
DEVELOPER
DRAIN
WASH DRAIN
4
1
8/1998