Kodak X-OMAT Multiloader 300 Installation Instructions Manual page 125
Hide thumbs
Also See for X-OMAT Multiloader 300:
- Service manual (244 pages) ,
- Service manual (36 pages)
Table of Contents
Advertisement
II 3058-4
5.
Prepare the PCB A12 with the remaining black PCB-SPACERS on the top left and the
bottom right in the right hand side hole.
6.
Install the INTERFACE CONTROL PCB A12 to the old position of the SLAVE
PROCESSOR PCB A3/2 and Fasten it with the two white plastic SCREWS.
Note
Check that none of the PINS on the PCB A4 are damaged when installing the PCB-A12.
7.
Install the SLAVE PROCESSOR PCB A3/2 on top of the INTERFACE CONTROLLER
PCB A12.
8.
Fasten the SLAVE PROCESSOR PCB A3/2 with one or two white plastic SCREWS.
Note
Some PCBs have just one hole.
9.
Disconnect the POWER CABLE from the CONNECTOR A4 X30 on the PCB A4. See the
figure on the previous page.
KODAK AG Stuttgart
figure 13-6
13-9
INSTALLATION INSTRUCTIONS
8/1998
Advertisement
Table of Contents
