Installation Of The Tubing And Electrical Connections - Kodak X-OMAT Multiloader 300 Installation Instructions Manual

II 3058-4
23. Make sure that the bottom edge reaches the correct position in the PROCESSOR
INTERFACE and the ROLLERS touch the door.
24. Close the INTERFACE DOOR.
25. Press the black curtain to the VELCRO strip on the WOODEN FRAME on the Dark
Room Side.
26. Check that the BLACK CURTAIN is light tight.
Note
If there are small needle holes in the black curtain it is possible to squeeze them with the
fingernails or move the texture with a pin in order to get it light tight. They can also be closed with
black silicone.

INSTALLATION OF THE TUBING AND ELECTRICAL CONNECTIONS

Refer to PART 2 of this INSTALLATION INSTRUCTION to install/reinstall the plumbing and
electrical connections.
INSTALLATION OF THE OPERATING SOFTWARE
TO SUCCESSFULLY INSTALL THE DARK-ROOM FILM FEEDER, THE XML 300 MUST HAVE
OPERATING SOFTWARE 3.24 OR HIGHER AND MOD 30 MUST BE INSTALLED.
Note
If the software is not successfully downloaded try it again. If the problem continues, locate it by
replacing the MICRO PROCESSOR BOARDS. If during the software update an error code ex0 to
ex42 is displayed, see the chapter ADDITIONAL MESSAGES in the DIAGNOSTICS MANUAL
DG 3058.
1. To download the OPERATING SOFTWARE to the HARD DISK of the LAP TOP, switch on
the LAP TOP
2. Change to drive A:
Key in: A: .........................................................................................press ENTER
3. Download the software:
Key in: install...................................................................................press ENTER
4. Change back to drive C:
Key in: C: .........................................................................................press ENTER
KODAK AG Stuttgart
INSTALLATION INSTRUCTIONS
13-15 8/1998