Installation Of The Dff Interface - Kodak X-OMAT Multiloader 300 Installation Instructions Manual
Hide thumbs
Also See for X-OMAT Multiloader 300:
- Service manual (244 pages) ,
- Service manual (36 pages)
Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
10. Connect the new DISTRIBUTION CABLE to the POWER CABLE A4 X30 CONNECTOR.
11. Connect the new DISTRIBUTION CABLE to the A4 X30 socket on the PCB A4 and the
CONNECTOR A12 X9 on the PCB A12.
12. Fasten the new DISTRIBUTION CABLE to the existing HARNESS with WIRE TIES.
13. Set the left-hand SWITCH of the DIP-SWITCH S1(PCB A4) to ON.
INSTALLATION OF THE DFF INTERFACE
1.
Disconnect the CABLE for the MOTOR M13 (STEPPER MOTOR PROCESSOR
INTERFACE) from the CONNECTOR A4 X16 on the PCB A4.
2.
Remove the two SCREWS to remove the old PROCESSOR INTERFACE on the rear side
of the XML 300.
PCB A4
PCB A12
PCB A3/2
8/1998
Wire Ties
adjust
SCREWS
figure 13-7
13-10
II 3058-4
SCREWS
KODAK AG Stuttgart
Advertisement
Table of Contents
