Kodak X-OMAT Multiloader 300 Installation Instructions Manual page 128
Hide thumbs
Also See for X-OMAT Multiloader 300:
- Service manual (244 pages) ,
- Service manual (36 pages)
Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
7.
Install the PROCESSOR INTERFACE to the XML300 / XML300 PLUS and route the
INTERFACE CABLE and the cable for the MOTOR M13 (STEPPER MOTOR PROCESSOR
INTERFACE) to the position of the PCB A12/PCB A4.
8.
Fix the INTERFACE CABLE and the MOTOR POWER CABLE with WIRE TIES.
!
Caution
THE CABLE MUST NOT TOUCH THE DRIVE GEAR AND THE DRIVE BELT OF THE
PROCESSOR INTERFACE!
9.
Loosen the 3 SCREWS of the PROCESSOR INTERFACE BRACKET (slotted holes) to
adjust the height (it must touch the bottom).
10. Fix the PROCESSOR INTERFACE with the 2 SCREWS.
11. Tighten the 3 SCREWS of the PROCESSOR INTERFACE (slotted holes).
12. Connect the INTERFACE CABLE to the connector A12 X 16 on the PCB A12.
8/1998
figure 13-9
13-12
II 3058-4
KODAK AG Stuttgart
Advertisement
Table of Contents
