II 3058-4
For XML 300 with serial numbers < 2001 :
3.
Install the INTERFACE CABLE/CONNECTOR to the new PROCESSOR INTERFACE and
fasten it with two WIRE TIES together with the MOTOR CABLE.
For XML 300 with serial number > 2000
and for XML 300 Plus:
4.
Install the INTERFACE CABLE/CONNECTOR to the existing PROCESSOR INTERFACE
and fasten it with a WIRE TIE together with the MOTOR CABLE.
5.
Install the socket for the GROUNDING WIRE to the PROCESSOR INTERFACE.
6.
If necessary, enlarge the slot at the plastic COVER to route the CABLES through.
KODAK AG Stuttgart
figure 13-8
13-11
INSTALLATION INSTRUCTIONS
8/1998